Yacht Devices YDSC-04N Switch Control NMEA 2000 Micro Male, 10 wire terminals

Yacht Devices YDCC-04N Circuit Control Micro Male, 4 x Bistable Relay

The Yacht Devices YDCC-04N Circuit Control is a core component of digital switching systems, providing seamless management of onboard electrical circuits. Equipped with four latching (bi-stable) relays, it allows control via connected buttons with LED indicators or over the NMEA 2000 network using standard messages.

Key Features

• Latching Relays: Four channels: two with normally open contacts (ON-OFF) and two with switching contacts.
• Efficient Power Use: Latching relays consume electricity only during the switching process and maintain their last state after power off.
• High Capacity: Maximum constant load current per channel is 10A, with a peak of 20A (for 4 seconds, duty cycle 10%).
• Versatile Load Support: Capable of switching both direct current (DC) and alternating current (AC) loads up to 400V.
• High Voltage Isolation: Provides 5000 VRMS isolation with the load.
• Low Power Consumption: Average device consumption is only 30 mA.

Integration and Control

The Circuit Control integrates with various control systems, allowing management from modern chart plotters, Web Gauges on Wi-Fi Gateways, or automatically from connected sensors. To set up additional control posts with duplicate physical buttons and indications, use the Switch Control YDSC-04.

The Circuit Control unit can operate in parallel with other units and can be managed from multiple Switch Control units with a matched bank number. Multiple independent digital switching systems can coexist in a single NMEA 2000 network.

System Examples

• Basic System: Single Circuit Control unit setup.
• Typical System: Multiple control panels integrated.
• Parallel Loads: Synchronized Circuit Control units managing parallel loads.
• Independent Systems: Two independent digital switching systems with different bank numbers.

Compatibility

The Circuit Control (firmware 1.01 or later) is compatible with most modern chart plotters supporting CZone, including Garmin, Lowrance, Simrad, B&G, Furuno, and recent Raymarine models. It is also compatible with Oceanic Systems, Offshore Systems, Chetco Digital, Maretron, and Carling Tech displays and relay modules, and other NMEA 2000 digital switching devices managed with standard NMEA 2000 PGN 127501 "Binary Status Report" and PGN 127502 "Binary Switch Control".

Product Benefits

• Compatible with a wide range of equipment, including modern chart plotters.
• No special requirements for buttons; any momentary push buttons can be used.
• Easy installation with no special knowledge, software, or hardware required.
• Suitable for small vessels due to its size and cost-effectiveness.
• Supports any type of load (AC, DC, audio) without heating or extra power consumption.
• Pure NMEA 2000 product, compliant with the standard and certified by NMEA.
• High-voltage isolation with the load and supports firmware updates.

Package Includes

• Circuit Control YDCC-04N
• User Manual

For additional technical details, please refer to the User Guide and FAQ.