1-2 weeks delivery time
Price incl. 19% VAT
Price incl. 19% VAT
Type:
- NMEA 2000 Micro Male
- SeaTalk NG Connector
Multifunctional signaling device for NMEA 2000 network. An external button with LED illumination and an acoustic system (speaker) with an impedance of 4 or 8 ohms can be connected to the device. The built-in 10W audio amplifier allows one of 28 audio signals (sirens, beeps, calls, tones and other signals) to be played.
- Description
- Ask a Question
-
The device can operate in one of three modes:
MOB button (default mode). Pressing and holding the button for 2 seconds triggers an alarm and sends AIS MOB messages with the current position of the vessel to the NMEA 2000 network, simulating messages received from EPIRB and SART devices with AIS/VHF support. In this case, a point with the MOB label will be fixed on the cartplotters. Pressing the button again stops the MOB message from being sent. Note that messages from the device are not sent to other ships via AIS/VHF transceivers, but will be available for all devices on the NMEA 2000 bus. Signal device for digital system Load Management. In this mode, the device functions as one standard unit of the NMEA 2000 Digital Load Management System comprising 28 channels. Each channel has its own sound signal and sequence of button LED flashing. Each channel (and the corresponding audio signal) can be turned on/off using other equipment, for example, from our "smart" sensors or from the virtual buttons of modern cartplotters. Alarm device for monitoring engine parameters. In this mode, the device includes audible signals when alarm and warning signals are received from a motor connected to the NMEA 2000 network. The device can also be set to operate at certain values of the engine operating parameters, for example, to exceed the temperature or the number of revolutions above the specified value. The device is recommended if the motor dashboard needs to be replaced.
Features:
- update firmware and replace sounds with CAN Log Viewer;
- multiple buttons can work together and Circuit Control modules can be used.
- compatibility with modern cartplotters Raymarine, B&G, Simrad, Furuno, Lowrance.
It is available in versions with a connector such as SeaTalk NG or NMEA Micro Male. Acoustic systems (speakers) with impedance of 4 or 8 ohms are supported. Output power (8 Ohm load, 13 V supply voltage): 10 W. Body length (without connector )/cable length: 54/600 mm.
Yacht Devices: YDAB-01N, YDAB-01R. -
Ask a Question
Popular products