Jabsco 30530-2104 - Stainless Steel Pump End Only

Jabsco 30530-2104 - Stainless Steel Pump End Only

Jabsco 30530-2104 is a 316 stainless steel Flexible Impeller pump with a Viton Impeller, Tungsten Carbide Mechanical Seal, 1-1/2 Inch NPT Internal Ports, replacement pump end only without a Motor. For this pump head select NEMA 184 TC-frame C-face motor rated at 5 HP at 1750 rpm with appropriate service factor. Motor must handle high-axial loads. Front ball bearing locked against axial movement is recommended. Motor must deliver 14.5ft-lbs and 43ft-lbs torque minimum in forward and reverse directions, respectively. This pump can be used where single or variable speed operation and 316 stainless steel material are desirable. Self-priming, 50 GPM (189 LPM) flow and debris-tolerant. The Viton impeller in this pump is good for hydrocarbons and solvents. This pump has a vertical dry suction lift of up to 6 feet with the Viton impeller, and will produce suction lift up to 22 feet when wetted. Be sure suction lines are airtight or pump will not self-prime. Temperature limits for Viton impellers are 60 degrees to 180 degrees F (15 degrees to 82 degrees C).

Stainless Steel flexible impeller pumps are especially useful where self-priming is required and are also very effective in pumping viscous or air-entrained liquids. At lower speeds, they also handle delicate liquids very well owing to their gentle pumping action. Virtually any liquid with viscosity up to 20,000 cps can be pumped as long as there is chemical compatibility with the pump materials. Stainless Steel flexible impeller pumps have the design features and materials suitable for pumping Corrosive chemicals, alcohols and solutions, Inks, dyes, paints and pigments, Viscous adhesives, thickeners and raw materials.

Do not pump gasoline or other flammable liquids. Motor is not explosion-proof. Do not run dry.